Advertisement
Quick start
1
Install the washing
machine
2
Load the laundry
3
measure out the
detergent
4
Close the
machine door
5
Put down (hang up)
the drain pipe
Programme selection
1
Press the POWER button.
2
Select the proper water level or other attached
3
To press the start/pause key.
The wash stops
When the wash stops,
the buzzer will buzz continuously for 6 times and
then the power will be automatically cut off.
Turn off the water
tap.
Although the power can be cut off automatically, the power plug must be pull
out as well for the safety.
9
Press the
[start/pause] key
8
Select the desired
programme
7
Plug the power supply
6
Turn on the water tap
functions.
11
The main wash
Instruction to the NORMAL program
! [Normal] wash program is the easiest, most convenient and most common washing
program. When the user press the power switch and then press [Start/Pause] button,
the normal washing program will start to work.
Steps in details
1.Press the power switch.
2.According to the washing amount choose the proper water level.
3.Press START/PAUSE button.
Instruction to single wash procedure
! User may freely select any single procedure, or any combination of procedures
among WASH, RINSE and SPIN according to the actual requirements. It is only
required to turn off any one or two of these three indicators that not needed by the
user. And keep the indicator be on showing the process needed by the user.
! Single wash -- after switching on the power, turn off RINSE and SPIN two indicators
by pressing these two keys. The operation for single rinse and single spin is similar.
! Single wash-spin – after switching on the power, turn off RINSE indicator by pressing
that key. The operation for single rinse-spin and single wash-rinse is similar.
Instruction to self-programmed procedure
! User can freely select any combination among WASH, RINSE and SPIN modes
according to the dirty degree of clothes.
Detail operation methods are following:
Continuously pressing the washing button to select washing time.
(6/9/12/15minutes, or no wash process)
Continuously pressing the rinse button to select rinse times.
(1~3 times,
recycle,
or no rinse process)
Continuously pressing the spin button to select the spin time.
(1/2/3/5 minutes or no spin process)
！
NOTICE
! Close the lid of the door when machine is running, otherwise, it will automatically
stop working during spin process and send out abnormal warning.
!The washer will not work when the filled water does not reach the set water level.
! After pressing down [ Power Switch ], if the [Start / Pause ] button is not pressed,
the power will be automatically cut off after 10 minutes.
12
Hide quick links:
Advertisement
