Turning The Tv On For The First Time - Hisense 55K220PWG Quick Setup Manual

Turning the TV on for the First Time

1. Connect the mains cable to the mains socket after you have completed all the
connections.
2. Switch on the power switch at the bottom of the TV.
3. The first time you turn the TV on, it will go straight into the Installation Guide. It will
assist you to specify the Language, Country, Use Mode, Service Statement (may
not be available, depending on your regions and country), Anyview cast, Network
Configuration and DVB Reception Type.
NOTE
Always disconnect the TV from the mains socket when it is not in use for a long
period of time. To completely disconnect the mains power, please remove the
mains plug from the mains socket or switch off the power switch.
4. Press the [▲/▼/◄/►] buttons to navigate the menu and change the settings.
Press the [OK] button to confirm.
Language
Country
Use Mode
Service
Statement
Anyview cast
Network
Configuration
Turning the TV on for the First Time
Select your desired language to be displayed on the menu.
Select the country where you will operate the TV.
Select your Mode Setting: Shop Mode and Home Mode.
Shop Mode: Optimizes the picture for store environments.
Home Mode: Recommended mode for the home use and low
power consumption.
Please note that Use settings are not saved after switching off
the TV when you select Shop Mode.
When the TV is turned on for the first time, Service Statement
will appear (May not be available, depending on your regions
and country). You can press the [OK] button to agree to use the
network services or press the [►] button to disagree, when you
entre the Network Configuration page with disagreement, Service
Statement will appear again until you choose "Agree" to use.
View the introduction of the Anyview cast function.
Connect your TV to access the network or the Internet.
Set Network Type to Wired Network.
Before setting, make sure your TV is connected to the network
by connecting the LAN port of TV to the external modem or
router using a LAN (Ethernet/Cat 5) cable. Refer to Network
Configuration >WiFi Network.
12