Advertisement
5. Exchanging rotating gobos/ Change lamp
• Always switch off the mains supply before installing or replacing the lamp.
• Never try to replace the lamp when it is hot.
• Do not touch the bulb with bare hands. If this does happen, clean the lamp with denatured
alcohol and wipe with a lint free cloth before installing.
Exchanging rotating gobos
6. Beam angle
It is best to be placed 5 meters from wall, and from this distance the light effect will cover an
area of 8.5 m x 5 m.
2. Safety Instruction
WARNING
♦
♦
♦
♦
Change lamp
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
Please read carefully the instruction, which includes important information
about the installation, usage and maintenance.
Please keep this User Guide for future consultation. If you sell the unit to another user,
be sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using the unit.
Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit.
It's important to ground the yellow/green conductor to earth in order to avoid electric
shock.
The unit is for indoor use only. Use only in a dry location.
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
Disconnect mains power before fuse/lamp replacement or servicing.
Replace fuse/lamp only with the same type.
Make sure there is no flammable materials close to the unit while operating as it is fire
hazard.
Use safety cable when fixes this unit.
Maximum ambient temperature is TA: 40℃. Don't operate it where the temperature is
higher than this.
Unit surface temperature may reach up to 85℃. Don't touch the housing bare-hand
during its operation. Turn off the power and allow about 15 minutes for the unit to cool
down before replacing bulb or serving.
In the event of serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage
or malfunction. Please contact the nearest authorized technical assistance center.
Always use the same type spare parts.
Don't connect the device to any dimmer pack or power pack.
Do not touch any wire during operation as high voltage might be causing electric
shock.
Advertisement
