Alber e-motion Operating Instructions Manual page 7

Operating instructions
Three functions can be controlled with the e-motion remote control:
1 = Switch on both e-motion wheels in support level 1 (LED [2] lights up briefly).
3 = Switch on both e-motion wheels in support level 2 (LED [2] lights up briefly).
4 = Switch off both e-motion wheels (LED [2] lights up briefly).
Note: All remote controls are delivered in a usable state complete with battery. If the LED [2] flashes then the battery capacity
is almost exhausted.
Under no circumstances should you carry the remote control in trouser pockets as potential inadvertent switching could result.
Ÿ
Instead use the cord provided (the length can be adjusted as required) or use the holder that can be attached to the
wheelchair.
Ÿ Take care not to drop the remote control and try to avoid all kinds of impact.
Ÿ Only operate the remote control when the wheels are at a standstill, never during a journey.
Changing the battery (see diagram on the jacket)
The useful life of the battery is dependent on the amount of use that the remote control gets.
If the range is markedly reduced or no functions work any more then the battery must be replaced.
Ÿ
Please observe the correct polarity when fitting the new battery!
Ÿ
After changing the battery tighten the screws by hand, but do not make then too tight. If the screws are tightened
Ÿ
too much the two sections of housing can be pressed together too much. Then the unit will no longer fit into the
holder on the wheelchair.
Use only 12V alkaline batteries.
Ÿ
The used battery must not be disposed of in the household rubbish. It must be taken to a public spent
battery collection point or one in a shop. Be sure to dispose of it in the container marked with the GRS sign.
1