USER GUIDE MULTI-CHANNEL STEREO MIXER S MIX 4M4S S MIX 4M4S D...
Page 2
FEATURES 4 mono input channels and 4 stereo input channels. 3-band frequency EQ for each input channel. Low-noise mic pre-amp on microphone inputs. Optional low cut filter to reduce low frequency interference for mono input channels. 10dB attenuator switch on stereo channel. Individual stereo play input and record output channel.
Page 3
CONTROL PANEL MONO CHANNEL SECTION 1. MIC This is an XLR type connector for microphones. The input level ranges from -60 to -20dB. This connector can provide +48V phantom power for condenser microphones when the phantom power is switched on. 2.
Page 4
STEREO CHANNEL SECTION 1. L/MONO - R These are two unbalanced 2-pole phone jacks for stereo line input. The input level range is -10dB. If the source signal is mono please use the left channel. 2. -10dB Press this switch to attenuate the line input signal -10dB to fi t a high level signal source.
Page 5
MASTER CONTROL SECTION 1. AUX SEND This jack socket sends the signals to an auxiliary source. 1. EFF SEND / FT SW (4M4S D MODEL ONLY) This is a 1/4” jack input for sending EFF output signals. It also can be linked to a foot switch to control the built-in effects processor.
Page 6
MASTER CONTROL SECTION S MIX 4M4S S MIX 4M4S D 14. AUX TO CTRL RM Press down this button to feed the AUX signal to the control room and headphones; and the AUX signal is not controlled by 13. 15. PHONES / CTRL RM This knob controls the signal level to the control room and headphones.
IMPORTANT SAFETY INSTRUCTIONS READ AND KEEP THESE INSTRUCTIONS. HEED ALL WARNINGS. • If, after you have followed the instructions outlined above, this device fails to function, please contact your dealer. Under no circumstances should this device be opened. Leave all servicing to qualified personnel.
Need help?
Do you have a question about the S MIX 4M4S and is the answer not in the manual?
Questions and answers