Do's And Do Not's - WaterTech softmax Owner's Manual

Dealer Contact and Product Information
Dealer Name:
Dealer Phone Number:
Model Number:
PrODuCT MusT Be reGIsTereD TO aCTIVaTe warranTY
VIsIT www.waTerTeCH.COM or Call 888-254-8412
• DO alwaYs check your state and local regulations regarding plumbing and electrical connections and
placement of the system before installation.
• DO install the system into the existing cold water supply line before the water heater and before any cold
water outlet that requires treatment.
• DO bypass your system in the event of a water or plumbing related emergency.
• DO inspect the brine tank monthly, if applicable.
• DO contact your WaterTech Dealer if you have any questions about the operation of your system or water
quality issues.
• DO enjoy all the benefits of your treated water!
• DO nOT hang or stack items on your equipment. This may cause an equipment imbalance or put a strain
on plumbing and electrical connections.
• DO nOT disconnect or remove any part of the plumbing or electrical cord.
• DO nOT attempt to reprogram your system. Your system has been factory or field programmed
specifically for your application.
• DO nOT overfill the brine tank with salt. Approximately 6 inches below the rim is the maximum
recommended fill.
• DO nOT allow your system and attached plumbing to be exposed to extreme temperatures (below 40°
F or above 110° F).
• DO nOT use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
Serial Number:

Do's and Do not's

1
Installation Date: