Entrotec RH3+ Instructions For Use

RH3+ HANDSET CONNECTION DIAGRAM

CW1308
WHITE/BLUE
DR
BLUE/WHITE
VT
WHITE/ORANGE
0V
ORANGE/WHITE
BZ
WHITE/GREEN
S2
GREEN/WHITE
S1
WHITE/BROWN
DS
PREFERRED COLOUR CODING FOR WIRING HANDSETS.
BROWN/WHITE
CB
WHITE/GREY
X
Apex Systems Only
From External Alarm
Output Trigger (12v on
alarm activation).
Installer Please Note:
1. All RH3+ handsets are fitted with a Call Tone Volume
adjustment. This maybe adjusted to suit level required.
Factory setting is full volume.
Manufactured in the UK
2. Terminal 8 must only be connected to an Extension
Sounder, Flashing Beacon or other Aux. Equipment.
DATE: 011/02/2011
DRG.NO.
ENTROTEC LTD
WIR/SCH0111/
Access House
5 Ashwood Court.
Oakbank
Livingston
001/Rev1V
EH53 0TL.
TEL.01506 886230
FAX.01506 886233
IMPORTANT. ALL CABLES TO BE KEPT WELL AWAY FROM HIGH VOLTAGE CABLES.
PLEASE CONSULT OUR INSTALLATION GUIDELINE SHEET OR CONTACT
OUR TECHNICAL DEPT. FOR ADVICE ON 08448586370.
DR 1
VT 2
0V 3
BZ 4
S2 5
S1 6
DS 7
EX 8
CB 10
X 11
ALM 12
DESC. DRAWN BY:
WIRING DIAGRAM
V.A.Turner
AND COLOUR
SCHEME FOR
RH3+ HANDSETS
ENTROTEC LTD.
RH3+ TELEPHONE-INSTRUCTIONS FOR USE
ON PRIVACY
ON
PRIVACY
DOOR OPEN
For AC/DC Buzzer Handsets
1) When called up the telephone will give a distinctive buzzing tone.
2). To answer the call remove the handset from the cradle and speak to
the caller.
3). To let the caller gain access, simply push the lock release button and
keep it depressed for approximately 5 seconds to allow the visitor gain
access.
4). When you have completed this, replace the handset in it's cradle.

PRIVACY SWITCH

5). If you do not wish to be disturbed or annoyed by nuisance calls, press the
privacy switch (the LED will illuminate to remind you that the handset is
in privacy mode). When in this mode the call tone is muted until you reset
the switch by pressing it again.
Privacy Switch
Privacy on LED
Door Open LED
Lock Release Button
GENERAL NOTES
The door entry phone system
is designed so that you have a
limited time to answer a call
and allow the caller access or
not. This is to save inconvenience
to other users of the system.