Advertisement
Note:
1.
To reset the default parameters to the
camera, please press and hold the
reset button and power on the camera.
You must press and hold the reset
button for approx 10 seconds.
2.
The TBV IP Camera supports audio
and alarm functions. The interfaces are
shown as follows.
Installation
Note:
Please make sure that the wall is strong
enough to withstand three times the
weight of the camera.
Steps:
1.
SD Card Installation
1.
Rotate the sunscreen M3X5 screw anti-
clockwise to loosen it. Slide the sun
shield according to the arrow direction
as shown in fig.1
2.
Remove the sun shield as shown in
fig.2
3.
Remove the front cover by rotating it
anti-clockwise.
4.
Insert the SD card to the SD card slot
(fig.3).
5.
Re-attach the front cover to the camera
and the sun shield as shown in fig.4
6.
Slide the sun shield as shown in fig.5
7.
Rotate the sunshield screw clockwise
to tighten the sun shield. (fig.6)
Fig. 1
Fig. 3
1. Sun Shield
2. Front Cover
3. Zoom and Focus Lever
4. IR LED
5. Lens
6. Air Vent
7. Video Output Interface
8. Integrated Bracket
9. Reset Button
10. SD Card Slot
11. Power Interface
12. Network Interface
Fig. 2
Fig. 4
Advertisement
