Asus Motherboard P4V800-X User Manual page 70

1. Install the Serial ATA hard disks into the drive bays.
2. Connect one end of the Serial ATA cable to the motherboard's primary Serial
ATA connector (SATA1).
3. Connect the other end of Serial ATA cable to the master Serial ATA hard disk.
4. Connect one end of the second Serial ATA cable to the motherboard's
secondary Serial ATA connector (SATA2).
5. Connect the other end of Serial ATA cable to the secondary Serial ATA hard
disk.
6. Connect the Serial ATA power cable to the power connector on each drive.
7. Proceed to section 5.4.2 "Entering VIA
procedure.
3.3.2 Entering VIA
1. Boot-up your computer.
2. During POST, press <Tab> to enter VIA RAID configuration utility.
The following menu options will appear.
The RAID BIOS information on the setup screen shown is for reference only.
What you see on your screen may not be exactly the same as shown.
Create Array
Delete Array
Create/Delete Spare
Select Boot Array
Serial Number View
Channel
Serial_Ch0 Master
Serial_Ch1 Master
On the upper-right side of the screen is the message and legend box. The keys on
the legend box allows you to navigate through the setup menu options. The
message describes the function of each menu item. The following lists the keys
found in the legend box with their corresponding functions.
F1 :
View Array/Disk Status
, :
Move to the next item
Enter :
Confirm the selection
ESC :
Exit
3-6
® Tech RAID BIOS Utility" for the next
®
Tech RAID BIOS Utility
VIA Tech. RAID BIOS Ver 1.XX
Create a RAID array with
the hard disk attached to
VIA IDE controller
F1
,
Enter: Confirme the selection
ESC
Drive Name Array Name
XXXXXXXXXX
XXXXXXXXXX
Chapter 3: Software support
: View Array/Disk Status
: Move to next item
: Exit
Mode Size(GB) Status
xxxxx xxx.xx Hdd
xxxxx xxx.xx Hdd