Functional Description - Craftsman 98820 Operator's Manual

FUNCTIONAL DESCRiPTiON
1. Switch box
2. Bail handle
3. Upper-handle
4. Lower-handle
5. Upper-handle attachment levers (2)
6. Lower-handle attachment levers (2)
7. Cut height adjust lever
8. Grass collection bag
9. Rear door cover
10. Battery port
11. Battery storage compartment
12. Carrying handles
IMPORTANT SAFETY
INSTRUCTIONS FOR BATTERY
CHARGERS
SAVE THESE iNSTRUCTiONS: This
manual contains important safety
instructions for battery chargers.
• Before using charger, read all instructions
and cautionary markings on charger,
battery pack, and product using battery
pack.
z_WARNING:
SHOCK HAZARD. Do not
allow any liquid to get inside charger.
zhCAUTION: BURNHAZARD. T o
reduce the risk of injur_, charge only
designated Craftsman batteries. Other
types of batteries may burst causing
personal injury and damage.
z_OAUTION:
Under certain
conditions, with the charger plugged in to
the power supply, the charger can be
shorted by foreign material. Foreign
materials of a conductive nature such as,
but not limited to, steel wool, aluminum
foil, or any buildup of metallic particles
should be kept away from charger
cavities. Always unplug the charger from
the power supply when there is no battery
pack in the cavity. Unplug charger before
attempting to clean.
_WARNING:
• DO NOT attempt to charge the battery
pack with any chargers other than the
ones in this manual. The chargerand
battery pack are specifically designed to
work together.
• These chargers are not intended for any
uses other than charging designated
Craftsman ® rechargeable batteries. Any
other uses may result in risk of fire, electric
shock or electrocution.
•
z_WARNING:
The charger supplied
with this product is intended to be
plugged in such that it is correctly
orientated in a vertical or floor mount
position.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when
disconnecting charger. This will reduce
risk of damage to electric plug and cord.
• Make sure that cord is located so that it
will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
• Do not use an extension cord unless
it is absolutely necessary. Use of
improper extension cord could result in
risk of fire, electric shock, or electrocution.
• Do not place any object on top of
charger or place the charger on
a soft surface that might btock
the ventilation slots and result in
excessive internal heat. Place the
charger in a position away from any
heat source. The charger is ventilated
through slots in the top and the bottom
of the housing.
• Do not mount charger on wall or
permanently affix charger to any
surface. The charger is intended to use
on a flat, stable surface (i.e., table top,
bench top).
• Do not operate charger with damaged
cord or plug -- have them replaced
immediately.
• Do not operate charger if it has
received a sharp btow, been dropped,
or otherwise damaged in any way.
Take it to a qualified service dealer for
inspection and possible repair.
• Do not disassemble charger; if it
malfunctions, take it to a quafified