Suzhou Kunteng Electronics KT-LCD2 User Manual

KT-LCD2 eBike Display User Manual
Dear customer, please read this manual before you use KT-LCD2 instrument. The manual will guide
you use the instrument correctly to achieve a variety of vehicle control and vehicle status display.

Functions and Display

Instruments using the structure form of instrument body portion and the operation buttons are
designed separately.
1
UP Button
2
SW Button
3
DOWN Button
4
Battery capacity indicator
Km/H
Riding speed(metric)
MPH
Riding speed (imperial)
5
MXS
MAX speed
AVS
Average speed

Operation

1. ON/OFF

Hold button long to turn on the power, and hold
power. When the motor stops driving and when the e-bike is not used for a consecutive 5 minutes, it will
automatically shut down and turn off the motor power supply.
2.
Display interface

2.1 Turn on backlight and headlights

TM
Single trip time
6
TTM
Total trip time
7
6Km/H push power assist
Km
Distance(metric)
Mil
Distance (imperial)
8
DST
Trip distance
ODO
Total distance
9 ASSIST
Pas level
long for a second time to turn off the
Hold button to start up and enter display interface.
V2.5
Hold long to turn on backlight and headlights (the controller should have headlight drive
output function); hold long again to turn off the backlight and headlights.

2.2 Assist ratio gear (ASSIST) switch

2.3 6Km/H assist promotion function

2.4 Display and delete of single data

automatically return the display interface after 5 seconds, original content is preserved.

2.5 Display of total trip time and distance

2.6 Display of single maximum speed and average speed

2.7 Battery capacity indicator display

Hold or shortly to switch 1-5 file gear. Gear 1 is
for the minimum power, gear 5 is for the highest power. Each
startup will automatically restore the gear shutdown last time.
Gear 0 is without booster function.
Hold and flashes, the vehicle drives at the speed
not more than 6Km/h. Release button, the function is
invalid.
After power on for 5 seconds, hold
same time, single trip riding time (TM) and single trip distance
(DST) flash, hold button shortly, the content of both is
cleared. If failed holding the button within 5 seconds, it will
Hold button shortly to display of total trip time (TTM)
and total trip distance (ODO). hold
return the display interface. In the riding mode after 5 seconds,
automatically returns to display interface.
In the display of total trip time and distance, hold
shortly to display of single maximum speed (MXS)and
average speed (AVS). hold button shortly again to return
the display interface. In the riding condition, 5 seconds later,
automatically returns to display interface.
The meter can automatically identify the battery capacity
when the battery capacity indicator is supporting use with the
and at the
button shortly again to
or