Vehicle Identification Plate - Mercedes-Benz 2016 S-Class Operator's Manual

Identification plates
426
radio frequency transmitting equipment).
Observe the legal requirements for retrofittings.
If your vehicle has installations for two-way radio
equipment, use the power supply or antenna
connections intended for use with the basic wir-
ing. Be sure to observe the manufacturer's addi-
tional instructions when installing.
Deviations with respect to wavebands, maxi-
mum transmission outputs or antenna positions
must be approved by Mercedes-Benz.
The maximum transmission output (PEAK) at the
base of the antenna must not exceed the fol-
lowing values:
Waveband
Short wave
3 - 54 MHz
4 m waveband
74 - 78 MHz
2 m waveband
144 - 174 MHz
Trunked radio/Tetra
380 - 460 MHz
70 cm waveband
400 - 460 MHz
Mobile communications
(2G/3G/4G)
The following can be used in the vehicle without
restrictions:
RF transmitters with a maximum transmis-
R
sion output of up to 100 mW
RF transmitters with transmitter frequencies
R
in the 380 - 410 MHz waveband and a maxi-
mum transmission output of up to 2 W
(trunked radio/Tetra)
Mobile telephones (2G/3G/4G)
R
There is no restriction for antenna positions on
the outside of the vehicle for the following wave-
bands:
Trunked radio/Tetra
R
70 cm waveband
R
2G/3G/4G
R
Identification plates
Vehicle identification plate with vehi-
cle identification number (VIN)
Maximum
transmission
output
Location of vehicle identification plate (exam-
100 W
ple, left-hand-drive vehicle)
X
30 W
50 W
10 W
35 W
10 W
Example: vehicle identification plate (USA only)
;
=
Example: vehicle identification plate (Canada only)
;
=
Open the front left-hand door.
You will see vehicle identification plate :.
VIN
Vehicle model
VIN
Paint code