Helpful Hints; Solid Surface Sink Maintenance; Interior Wall Panel; Flooring - Jayco 2016 White Hawk Owner's Manual

JAYCO TOWABLE
Disinfect the surface periodically with diluted household bleach (one part water to one part
bleach). For cuts and scratches, sand the matte finish lightly with (220) fine grit sandpaper
until the cut or scratch is gone. Restore finish with a green Scotch Brite
abrasive cleaner.

Helpful hints


Use a cutting board to prevent unnecessary damage to the countertops. Do not cut
directly on the solid surface countertop.

Use potholders or trivets before placing hot pots and pans on the countertop. Heat
will damage the countertop.

Run cold water when pouring hot/boiling water into the sink.

Solid surface sink maintenance

Occasionally, clean the solid surface sink by filling one-quarter full with a 50/50
water/bleach solution. Let soak for 15 minutes, and then wash sides and bottom of sink as
solution drains.
I W
NTERIOR ALL
Please contact your dealership service department for assistance in repairing décor
paneling. If deep scratches occur on the wall panel, putty sticks can be used to cover
scratches on wood surfaces. These can be obtained from local hardwood stores and
lumberyards.
To clean, use a mild solution of soap and lukewarm water with a soft sponge or cloth.
Wipe dry with a soft, clean cloth.
Do not use abrasive cleaners as they may cause the vinyl to scratch and become dull.
Do not use cleaners that contain bleach
F
LOORING
Always test a cleaning agent in an inconspicuous area for colorfastness.
Carpet
Vacuum your carpet regularly. It is important to remove loose soil and debris while it is
on the surface. Heavily traveled areas (i.e., walkways, areas in front of the furniture) may
be protected with small throw rugs to prolong the life of the carpet.
Prompt attention to spots and spills is essential. Remove as much of the spill as possible.
Absorb wet spills as quickly as possible by blotting repeatedly with white paper or cloth
towels.
Refer to the manufacturer's guide included in your Warranty Packet for detailed cleaning
information, or contact a cleaning professional.
Vinyl flooring
Periodically vacuum or sweep to remove dirt and gritty particles. Although most common
spills will not permanently stain the vinyl floors, they are usually easier to remove if wiped
up before they set. Simply blot with a paper towel and wipe clean with a damp cloth. Do
not use dish detergents or vinegar and water because they will dull your floor.
To care for the vinyl floor covering, use a damp mop with water and a mild cleaner on the
entire floor. DO NOT SOAK THE FLOORING. Use care to avoid wetting the carpet
edges. To avoid problems of "yellowing" linoleum, the flooring manufacturer recommends
avoiding cleaners that contain oil based solvents (i.e. cleaners containing lemon oil,
Murphy's Oil Soap, etc.).
P
ANEL
CAUTION
SECTION 12 - INTERIOR
12-5

pad and mild