Loopcomm LP-8696P Instruction Manual

Step1
Normal Power 100mW Compact Wi-Fi Range Extender
Find an optimal setup location between your Wireless Router and
your wireless dead zone
Step2
Connect your PC or Tablet to the Smart Repeater
Step3

Open your Web Browser

Recommended browsers: Google Chrome, Safari or Internet Explorer (8.0 or up) Do not use Firefox
Disconnect your PC from wireless networks, open your browser and try again.
Windows 7 & Vista
1.Click on the wireless icon to see available wireless networks
(For vista, click start> Connect To)
2.Select your current Wireless Network and click
3.Press WPS button for 5Seconds to restart the Smart Repeater
and wait for 60Seconds and try
http://setup.loopcomm.com again.
Step4
Welcome to Dashboard
Step5

Scan for a wireless Network

Step6
Home Network Security Settings (If necessary)
Step7
Configure Settings for your Extended Network
Step8
Connect to the New Extended Network
Step9

Setup Summary

LP-8696P
Indoor 802.11B/G/N 2.4G Wireless Smart Repeater
(example)
Disconnect
Loopcomm_Repeater
Finish Refesh
http://www.loopcomm.com
Side and Bottom Panel Description
Antenna : Two 2dBi fix external Antenna.
SMART REPEATER
Smart Repeater
Connect the Cable RJ-45 to Smart Repeater
and to computer or Notebook Port
Plug the Smart Repeater to Power Plug
Enter the setup web address into your browser:
http://setup.loopcomm.com
If the URL fails to open, then try http://192.168.1.250
loopcomm
The Dashboard will provide you with the current
status of the Smart Repeater.
Click Scan to find available networks to extend
Click Scan to begin scanning for nearby wireless
networks.
Highlight and select the wireless network(S) that
you wish to repeat.
Recommended signal
Select the wireless network with
a signal strength greater than 70%
for the most reliable connection
Click Next to Continue.
Enter your password and then click next.
If your wireless home network(s) does not have
security enabled, leave the security field blank.
Click Next to Continue.
The ID of your extended network is:
Loopcomm_Repeater
To change it, enter a new name in the SSID Field.
Wireless Users connecting to the range extender
can use this ID to identify the extended network.
Enter a new key in the security key field. The key
must be at least 8 characters long.
Click Next to apply your settings. The smart Repeater
will reboot. This process may take up to 150seconds.
Don't refresh the web page.
The page will automatically reload with the connection
status.
During the countdown process, the Range extender
will reboot and disconnect the Wi-Fi connection. At
this point, you need to reconnect your PC or tablet to
the new extended network. Follow the instruction on
the screen to connect to the extended network.
Once you have connected, click the check box to
confirm.The Next button will appear allowing you to
complete the setup process.
If there are problems with your configuration, the
setup wizard will inform you to rescan for a network
to extend.
If there are no problems, you will see the setup
summary page below.
Congratulations, the smart repeater is now
successfully configured. Your settings are now
saved. You may now detach the Ethernet cable
from your computer and connect to wireless
smart repeater.
You may also attach any wired network
devices to the wired ports on the back
of the smart repeater.
Press Finish to complete the process.
If there is a problem with your configuration,
then the smart setup wizard will inform you to
restart the wizard and select another network
to repeat.
READ FIRST
Quick Install Guide 1.0.0
Press 3Seconds for
WPS configuration
Press above 5Seconds
to reset
RJ-45 Port for connecting
to computer
Power Plug