Table of Contents
Advertisement
2.
Camera Cabling
Please follow the instructions below to complete IP Camera connection.
2.1
Connect Power
Please refer to
the camera's PoE port and plug the other
NOTE: If using PoE, make sure Power Sourcing Equipment (PSE) is in
use in the network.
2.2
Connect Ethernet Cable
Use of Category 5 Ethernet cable is recommended for network connection; to
have best transmission quality, cable length shall not exceed 100 meters.
Connect one end of the Ethernet cable to
Camera, and the other end of the cabl
NOTE: In some cases, you may need us
when connecting the IP Dome Ca mera directly to the PC.
Check the status of the link indicator and ac
unlit, please check LAN connection.
2.3
Connect Alarm I/O
The camera equips one alarm input and on
Refer to alarm pin de nitio n below to connect alarm devi ces to the IP Camera if
needed.
Section: Connectors
Green Link Light indicates good network connection.
Orange Activity Light ashes for
PIN 1: GND (Input-)
PIN 2: Input+
PIN 3: Output-
PIN 4: Output+
. Alternatively, connect the Ethernet cable to
end of the cable into a PoE switch.
the RJ-45 connector of the IP Dome
e to the network switch or PC.
e an Ethernet crossover cable
tivity indicator LEDs; if the LEDs are
network activity indication.
e relay output for alarm application.
7
Advertisement
Table of Contents
