Changing The Presser Foot; Removing The Presser Foot Holder - Royal EVA 8700 Instruction Manual

CHANGING THE PRESSER FOOT

The presser foot must be changed according to the
CAUTION:To prevent accidents.
Turn OFF the power switch before you change the presser foot.
1. Turn the handwheel toward you until the
needle is at its highest position.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the
presser foot release lever toward you.
4. Place desired foot with its pin
the slot in presser foot holder.
B
5. Lower the presser foot lifter and the presser
foot will snap into place

REMOVING THE PRESSER FOOT HOLDER

You may need to remove the presser foot holder to use
some presser feet.
To remove, raise the presser foot lifter and loosen the
presser foot thumb screw (C).
To attach, tighten the screw after raising the presser foot
holder.
INSERTING THE NEEDLE
Select a needle of the right type and size for the fabric to be sewn.
(See Fabric, Thread and Needle Table on page 23).
CAUTION:To prevent accidents.
Turn OFF the power before removing the needle.
1. Turn the handwheel toward you until the
needle is at its highest position.
2. Loosen the needle clamp screw.
3. Remove the needle.
4. Insert new needle into needle clamp with
the flat side to the back and push the needle
into the clamp until it reaches stopper.
5. Tighten the needle clamp screw.
A. Place needle on a flat surface and check
to see if bent.
Do not use any bent or dull needles.
sewing job
A directly under
11
or stitch you sew.
3
C
B
4
A Presser foot pin
Presser foot holder slot
B
Presser foot thumb screw
C
1
4
3
2
5
1
A
2 5
A