babymoov Visio Care A014403 Instruction Manual page 12

Problems
• No transmission.
• Transmits without interruption.
• No image on screen only audio is
heard.
• Image becomes black and white.
• lot of static and interference.
• Too short communication range .
12
IN C SE OF PROBLEMS
Possible cause
• The receiver battery is flat.
• The units are out of range.
•The transmitter is set in continuous
transmission mode.
• Power and screen On/Off switch (6) is on
position "LCD Off".
• The lens is covered by its protective film.
• Light intensity too low in baby's room ;
baby unit operates under night vision
mode using infrared LED as source of
illumination.
• The transmitter is located close to other
electrical apparatus
.
• large number of steel structures
between the transmitter and the receiver.
B BY MONITOR VISIO C RE • Instruction Manual
Solution
• Charge up the battery of the receiver or
check the connection.
• Bring the transmitter and the receiver
closer to each other.
• Switch the VOX/On camera switch (20) to
" uto" position.
• Move the switch (6) to position On.
• Remove the protective film from the
camera lens.
• Increase light intensity of baby's room.
• Remove the electrical appliances or move
the transmitter away from the source of
interference .
• Reposition the transmitter and the
receiver.