Closing The Door - Frigidaire FRFF200W User Manual

PROBLEM
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
POSSIBLE CAUSE
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the evap-
orative tray above the
compressor.
The QuickFreeze or Quick-
Chill function is switched
on.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The QuickFreeze function
is switched on.
There is no cold air circula-
tion in the appliance.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
TROUBLESHOOTING
SOLUTION
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off QuickFreeze or
QuickChill manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "QuickFreeze or
QuickChill function".
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "QuickFreeze func-
tion".
Make sure that there is cold
air circulation in the appliance.
"Installation".
15