Advertisement
Quick Links
Advertisement
Related Manuals for Fusion Bikes Vintage
Summary of Contents for Fusion Bikes Vintage
- Page 1 Fusion Vintage Bike Instruction Assembly Guide...
- Page 2 Please note that if you are not familiar with mountain bike components and have limited in experience in this field, we strongly recommend you take it to a professional for proper assembly. This assembly manual is suitable for the following models: Vintage Ladies Classic Model 2013 (Model) • Vintage Ladies Classic Model 2014 (Model) •...
- Page 3 STEP 2: Now that we have the right tools, let begin by removing the bike out of the box Step 3: Remove protective plastics and cable tie from bike. Be careful not to cut the brake cable during this process.
- Page 4 Step 4: Empty contents from small box Step 5: Install handle bar on bike stem. Use allen key provided in small box and tighten firmly.
- Page 5 Step 6: Place seat on frame and tighten, If you are a novice rider place seat at a lower height. Otherwise, you should just be able to tip toe with your feet when sitting on the seat. Step 7: Place bike upside down. Place small box underneath rear mud guard to help support this process...
- Page 6 Step 8: Unclip front brakes by slipping cable from catchment (see arrow). Connect the front mud guard to the rear of front fork and tighten screw. Step 9: Screw metal support onto front forks. When screwing in bolt make sure that you do not damage thread on screw.
- Page 7 Step 10: Loosen bolts on front wheel Step 11: Place front wheel onto fork. There is a small hole in fork feed metal hook through here (see arrow).
- Page 8 Step 12: Install pedal on crank arm. To tighten rotate spanner in the direction of how you would pedal. Note: if pedal is not biting on thread you may be installing the wrong pedal on arm. Step 13: Loosen both boths on either side, bolts are located below saddle.
- Page 9 Step 14: Connect a metal rod to each side and screw bolt back on. Note the curve of rode is concave up. Step 15: Loosen bolt on bottom of frame. One on each side.
- Page 10 Step 16: Install rear rack and tighten bolts from Step 15. Step 17: Screw the round nut onto the inside of bracket. Then connect bracket to rear rack. Bracket...
- Page 11 Step 18: Once attached, feed metal bars through bolt and tighten nut. Bolt/Nut Bracket Metal Bar Step 19: Congratulations. The assembly is complete. Well done!!!
- Page 12 Q&A COMMON ISSUES WITH BIKE INSTALLATION: Question: The front tyre is rubbing the mud guard what should I do? Answer: Place bike upside down and loosen the metal bar [A] where it attaches to the mud guard. The guard may have shifted when taken out from box. Make sure it is aligned and retighten.
- Page 13 FRONT WICKER BASKET INSTALLATION (WHERE INCLUDED) Step 21: Follow the instructions below only if you have purchase the front basket. You will be provided a separate box with nuts & bolts, bracket, support and basket. Firstly connect the support bar to the front of bicycle fork as depicted. Nuts &...
Need help?
Do you have a question about the Vintage and is the answer not in the manual?
Questions and answers