Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SKP Pro Audio DMP-4010
Summary of Contents for SKP Pro Audio DMP-4010
- Page 2 Important To Safety WARNING: NOTE: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT This CD player uses the semiconductor laser. To allow EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. you to enjoy music at a stable operation, it is recommended to use this in a room of 5 ℃ 41 ℉ - 35 ℃ CAUTION: 95 ℉...
- Page 3 Features 10 seconds of anti-shock memory Selectable elapsed, remain total Instant start remaining time (audio only) display Seamless loop Single/continuous play Pitch range: +/-100% +/-0.1% (+/-16% for Relay play allows consecutive playback MP3) during two players 4 hot cues for Sampler and Cue memory, S/PDIF digital audio RCA coaxial <5 sec.
- Page 4 4%,8%,16%,100% PITCH SELECT BUTTON － again. RELOOP BUTTON － If a seamless loop has Press the button in order to change pitch been made, but the CD player is not actively in percentage of 4%,8%,16%,100%. 4 HOT CUE BUTTONS － Press the desired seamless loop mode (a loop is not playing), pressing the RELOOP button will instantly BANK button when the MEMORY LED is lit will...
-
Page 5: Control Unit
25. RELAY SOCKET － Via the RELAY SOCKET, two CD players can relay play. If you connect with a mixer which supporting fader start, you can also relay play via mixer’s cross-fader. 26. POWER SWITCH － Press this button to start operation. -
Page 6: Specifications
Set-up 1.Checking the Contents Check that the carton contains the following items: 1. Main unit 2. Operating instructions 3. A RCA pin cord. 4. A AC power cord. 2. Installing the Unit 1. Place your unit on a flat surface. 2. - Page 7 Operating instructions 1.Opening and Closing If track is changed before pressing play, the cue point is This operation only works when the power is on. changed to the new starting point. Press the OPEN/CLOSE button to open or close the disc If you pause during playback this also sets the new cue tray, or press PLAY button, the disc tray automatically point.
- Page 8 Operating instructions 12. Seamless Loop Play (Cont.) Both player’s CONTROL jack are connected to Mixer’s a- (Must be in SEAMLESS LOOP mode). If a SEAMLESS CROSS FADER signal output CH1 or CH2; when the LOOP has not been created, follow instructions on this jack are connected, the operation for both player as page creating...
-
Page 9: Before Switching Off The Power
Before Switching off the power CAUTION: Do not forcibly close the disc holder when the power is off. Do not switch off the power when the disc To avoid damage, pls don switch off the power until holder is open.
Need help?
Do you have a question about the DMP-4010 and is the answer not in the manual?
Questions and answers