Table of Contents
Advertisement
access to the heating elements and must be in place when
the heater is in use.
•
The fireguard does not give full protection for young
children and for infirm persons.
•
Plug the mains lead into a 13 Amp mains socket that is
protected by a 30mA Residual Current Device (RCD). Never
use equipment outdoors that is connected to a socket that is
not protected by an RCD.
•
If connecting via an extension lead, make sure that the lead
is rated at 10 Amps or more, and that it is fully unwound.
•
Switch the appliance on at the mains socket.
•
Pull the cord-operated switch to select the required
operation:
Figure "1" displayed = Low Heat (1000 W)
Figure "2" displayed = High Heat (2000 W)
•
Do not touch the grille when the heater is in operation,
because it will be hot and may cause burns.
•
Unplug the heater from the mains when not in use.
•
To adjust the angle, switch off the heater and allow it to
cool for 15 minutes. Slacken the pivot screw, and adjust the
reflector to the preferred angle. Re-tighten the screw. The
heater may now be switched on.
When not in use, or during inclement weather, the black
fabric dirt and dust protector should be deployed. Always
make sure that the heater is unplugged and cannot be
accidentally switched on when the dirt and dust protector is
being used.
OPERATION
STORAGE
Page 5
Advertisement
Table of Contents
