Operation Instruction; Cleaning - Bi-rich BR-CN116 Instruction Manual

Operation Instructions
1. Place compressor on a stable, sturdy and flat surface so that the unit can be
easily reached when you are seated.
2. Pull out the power cord from the base of the unit ,and make sure that the unit is in
the " off"（O）position by pressing on the left side of switch.
3. Plug power cord into a wall outlet.
4. Connect one end of the nebulizer tubing into the air outlet connector.
5. Add the prescribed solution through the opening on cap using an eye dropper or pre-
measured dose container.
And the marking "6cc" marked on the nebulizer cup is the maximum level
And the medication can not be filled beyond the maximum level
6. Assemble mouthpiece and T-mouthpiece, and insert into the top of the nebulizer
cap. If an aerosol mask is used ,connect the bottom of mask to the top of
nebulizer cap.
7. Connect tubing to nebulizer air inlet connector.
8. Turn the power on to start the unit.
9. Implement the treatment by placing the mouthpiece between the teeth. Inhale
and exhale through the mouthpiece.
10. If an aerosol mask is used, place the mask over the mouth and nose.

Cleaning

1. Turn the power off and unplug from the wall outlet .
2. Remove the tubing from the air inlet.
3. TO CLEAN: Disassemble mouthpiece, T-mouthpiece, nebulizer cup, chamber
and baffle, and wash this items in hot water with dish-washing detergent
Rinse these items thoroughly to remove the detergent and let air dry.
4. TO DISINFECT: Mix one part of white vinegar with 3 parts hot water in a clean
container. Submerge mouthpiece, T-mouthpiece, nebulizer cap, chamber and
baffle for half an hour in the solution. Remove from solution and let air dry.
5. There is no need to clean the tubing. If necessary wipe the surface regularly.
CAUTION:The jet nebulizer must be changed if it gets clogged.
CAUTION:The nebulizer and accessories must not be boiled.
6