Page 1
HVLP Gravity Feed Spray Gun Kit Instruction Manual 19220 Need help? Call our customer service hotline at 1-800-386-0191 For up-to-date product information, accessories and for a Spanish version of this manual, please visit our website at: www.titan-us.com and click on the literature link or scan the QR Code at left with your smart phone.
1-800-386-0191 Please have the model number, and date of purchase available for reference when calling. MODEL NUMBER: 19220 DATE of PURCHASE:...
Page 3
IMPORTANT SAFETY RULES FOR ALL SPRAY GUNS IMPORTANT SAFETY RULES FOR ALL SPRAY GUNS SAVE THESE INSTRUCTIONS SAVE THESE INSTRUCTIONS Read and understand all instructions. Failure to follow all instructions HAZARD included with this product could result in serious personal injury and/or Risk of breathing property damage.
INTRODUCTION Before disassembly or removal of any part of gun or attached Your new VAPER spray gun is a vital link in the finishing application. In addition to operating components, shut off air supply to gun, shut off air compressor,...
Page 5
PRESSURE FEED CIRCULATING HOOKUP TYPE OF SPRAY GUN HOOKUPS For heavy production spraying, air pressure for atomization is controlled by the regulator on the air source, The fluid pressure is SIPHON FEED CUP HOOKUP regulated by a separate fluid regulator at the paint source. Air pressure for atomization is controlled by the regulator on the air source.
PREPARATION FOR SPRAYING FAN DIRECTION DO NOT ATTEMPT TO UNCLOG (BACK FLUSH) SPRAY GUN BY The position of the air cap horns determines the directions of the SQUEEZING TRIGGER WHILE HOLDING FINGER IN FRONT OF FLUID fan (horizontal or vertical spray pattern). Loosen the lock ring on NOZZLE.
PATTERN ADJUSTMENTS FOR PRESSURE HOOKUPS CARE AND MAINTENANCE 1) Adjust air pressure to the spray gun according to the recommendations supplied by the spray Always wear safety goggles that comply with ANSI standard Z87.1 when cleaning spray guns. material manufacturer. This air pressure is typically between 40 to 60 psi for conventional spray guns.
Page 8
5) After using water to clean out water based paints or materials, spray mineral spirits through AIR NOZZLE, FLUID TIP, NEEDLE ASSEMBLY the gun to prevent corrosion. 6) Lubricate gun after cleaning using light machine oil. To prevent damage to the fluid tip of fluid needle, be sure to either: 1) pull the trigger and hold while tightening or loosening the fluid tip, Never use lubricants containing silicone as these lubricants can or 2) remove fluid needle adjusting screw to relieve spring pressure...
TROUBLESHOOTING TROUBLESHOOTING (Continued) Problem Encountered Possible Cause Corrective Action Problem Encountered Possible Cause Corrective Action Heavy top or bottom pattern Horn holes plugged. Clean. Ream with non-metallic point. Excessive overspray. Gun too far from work surface. Adjust to proper distance. Obstruction on top or bottom of fluid tip.
Spraying technique and personal preference must also be considered. SPRAY GUNS AND ACCESSORIES AVAILABLE FROM VAPER For up-to-date product information, and for a Spanish version of this manual, please visit our website at: www.titan-us.com and click on “Literature” or scan the QR Code at left with your smart phone.
90 DAY LIMITED WARRANTY Star Asia-USA, LLC (hereinafter “seller”) warrants to the original purchaser only, that this product will be free from defects in material or workmanship for a period of 90 days from date of purchase for home domestic use. Warranty Performance Warranty coverage is conditioned upon purchaser furnishing seller or its authorized service center with adequate written proof of the original purchase date.