Unpacking And Installation Although it is neither complicated to install nor difficult to operate your Remote Amplifier, a few minutes of your time is required to read manual for a properly wired installation and becoming familiar with its many features and how to use them. Please take a great care in unpacking your Remote Amplifier and do not discard the carton and other packing materials.
Features Attached Combination Jack for gooseneck microphone or any wired microphones. Low noise high gain mic pre amplifier with gain POT and mute switch. Including natural 4-note chime sound with gain POT. Two mid band equalizer support for controlled human voice spectrum. Built in amplifier and speaker served internal or external sound source.
+60dB 1. Main Power Switch - Power "ON" and "OFF" procedure. Please turn on this rocker switch before operating the ERM-2120, 2240, 2320 series remote amplifier. The "POWER" green color LED is indicating when enclosed external 24VDC/1A DC adapter working properly.
ALL switch but return to preset status when release the specific ALL switch. 2. ZONE SELECTOR/CHANNEL SWITCH - Control switch with LED indicator. (ERM-2120=x12, ERM-2240=x24, ERM-2320=x32 each of channel selector switches) Each channel switching circuit supports individual switching point between channel out and combined "REMOTE COM"...
Page 7
Appear in complete 4-notes chime signal when it pressed one time. 5. MONITOR/MONITOR volume - Control to internal speaker monitoring volume. The ERM-2120/2240/2320 remote amplifier integrated 2inch(50m/m)/1W speaker with small power amplifier for monitoring internal chime signal or external signal source.
SIGNAL SIGNAL MONITOR MONITOR EQUIPMENT TO RAIN OR MOISTURE. MADE IN KOREA MADE IN KOREA OUTPUT OUTPUT INPUT INPUT www.ekars.co.kr www.ekars.co.kr 32 31 31 30 30 29 29 28 28 27 27 26 26 25 24 23 23 22 22 21...
Mode selector switch combinations MODE SELECTOR ON / OFF REAR SIDE SW 3 SW 2 SW 1 The power switch should turn off before The power switch should turn off before ALL PHASE V-SOURCE V-OUT <BOTTOM SIDE VIEW> SW 6 SW 5 SW 4 making new switch combinations.
Specifications Mic headamp Maximum Gain ----------------------------------------------------------------------------------- +60dB Signal to noise ratio ----------------------------------------------- More than -60dB(Gv=+60dB, 150ohm terminated, BW=20Hz to 20KHz) Frequency response ----------------------------------------- 80Hz to 18KHz(-3dB/Gv=+40dB) THD ------------------------------------------------------------ Less than 0.1%(Gv=+60dB, 1KHz) Equalizer Low middle ---------------------------------------------------------- F0=500Hz Peaking, +/- 12dB High middle ----------------------------------------------------------- F0=5KHz Peaking, +/- 12dB Chime 4-note chime -------------------------------------------------------------------------- Do, Mi, Sol, Do...
Need help?
Do you have a question about the ERM-2120 and is the answer not in the manual?
Questions and answers