On-Board Computer (Vehicle With Out Steering Wheel Buttons) - Mercedes-Benz Metris Operator's Manual

On-board computer (vehicles without steering wheel buttons)
174
message with 3, the display shows the next
submenu.
Press f or g to activate or deactivate ESP.
X
Press 3 to confirm.
X
The next submenu is shown in the display.
If the å warning lamp in the instrument
cluster lights up when the vehicle is ready to
®
drive, ESP is deactivated.
Observe the information on warning lamps
( page 221) and display messages
Y
( page 193).
Y
Setting the sensitivity of the rain sensor
The vehicle must be stationary. Use the buttons
in the instrument cluster.
Press È to select the
X
Press 3 to select the
X
menu.
The display shows the current sensitivity set-
ting.
Press f or g to select the Low,
X
Sensitive setting. This setting controls the
rain sensor's sensitivity to precipitation. The
windshield wiper will then wipe more or less
frequently at the same precipitation intensity.
Press 3 to confirm.
X
The next submenu is shown in the display.
You can find further information under "Wind-
shield wiper" (
Y
Activating/deactivating ATTENTION
ASSIST
The vehicle must be stationary. Use the buttons
in the instrument cluster.
Press È to select the
X
Press 3 to select the
X
submenu.
The display shows the current status.
If the Attention Assist Inoperative
message is shown in the display, ATTENTION
ASSIST is not available due to a malfunction
and is deactivated. If you confirm the mes-
sage with 3, the display shows the next sub-
menu.
Press f or g to activate or deactivate
X
ATTENTION ASSIST.
Press 3 to confirm.
X
The next submenu is shown in the display.
Settings menu.
Rain Sensor
Standard
page 101).
Settings menu.
Attention Assist
Further information can be found under "ATTEN-
TION ASSIST" (
Selecting the permanent display func-
tion
With the Permanent Display:
can switch the display in the header between
outside temperature and speed.
If the display shows the speed in the header, the
outside temperature is shown with the odome-
ters ( page 171).
Y
The additional speedometer unit in the header is
always inverse to the speedometer unit.
The vehicle must be stationary. Use the buttons
in the instrument cluster.
Using È select the
X
Using 3 select the
X
sub-
submenu.
The display indicates the selected setting of
Outside Temp.
Change the setting by pressing f or g.
X
or
Press 3 to confirm.
X
The next submenu is shown in the display.
Selecting the unit for the distance
In the Distance Unit:
select whether the display shows certain infor-
mation in kilometers or miles.
The vehicle must be stationary. Use the buttons
in the instrument cluster.
Press È to select the
X
Press 3 to select the
X
menu.
The display indicates the selected setting of
km or Miles.
Change the setting by pressing f or g.
X
Press 3 to confirm.
X
The display shows the next submenu or the
Settings
The selected distance units are used for the dis-
plays:
Digital speedometer
R
Odometer and trip odometer
R
Trip computer
R
Range
R
Current consumption
R
Cruise control
R
Service intervals
R
page 149).
Y
function, you
Settings menu.
Permanent Display:
or Speedometer.
submenu, you can
Settings
Distance Unit:
menu again.
menu.
sub-