After The Ride; Maintenance - XciteRC twenty 4 Instruction Manual

After the ride · Maintenance
left) and turn the adjusting knob ST.D/R slowly to the right until the desired steering angle is reached. You
may do this setting also while running your vehicle. WARNING: do not turn too far, otherwise the steering
arm press against the front uprights which may damage the steering servo!
-
+

After the ride:

1. Switch OFF the vehicle first, then the transmitter (ON/OFF-switch in position O).
OFF
2. WARNING: remove the batteries from the model – fire hazard!

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!
twenty4 series
+
EN
23