Table of Contents
Advertisement
Watching TV
Option Setting
OPTION
Language / 語言
You can select a language from the setup menu.
3 languages are available: English, Simplified
Chinese and Traditional Chinese.
Press MENU and the MENU screen displays.
1
Press c / d to select "OPTION".
2
Press a /b to select "Language/
3
then press OK.
Press a /b to select the desired language
4
listed on the screen.
PVR File System
You need to set the PVR file system before you record
programme you desired.
Press MENU and the MENU screen displays.
1
Press c / d to select "OPTION".
2
Press a /b to select "PVR File System", and
3
then press OK.
Press a /b, c / d and OK to set the PVR File
4
System.
Select Disk
Check PVR File System
USB Disk
Format
Time Shift Size
Speed
Free Record Limit
NOTE
• This function only available in DTV mode.
• Before using Time Shift function or recording function, it is necessary
to format USB storage clear first.
• All the data in the USB storage device will be deleted after formatting.
• The maximum supported storage capacity of hard disk is 1TB.
M3H_EN_160126.indd 21
L an g u a g e / 語 言 En g li s h
P V R Fi le S ys tem
R es to r e Fa c to r y D e f a u l t
O S D T i m e O u t
B lu e S c r e e n
O S D T r an s p a r e n cy
", and
C:
Start
6 Hr.
MENU
Restore Factory Default
If complex adjustments are made and the settings can
not be restored to normal, you can reset the settings
to the factory preset values.
Press MENU and the MENU screen displays.
1
Press c / d to select "OPTION".
2
Press a /b to select "Restore Factory
3
Default", and then press OK.
Press c / d to select "Yes" or "No".
4
OSD Time Out
Allows to set the display time of the on-screen menu.
Press MENU and the MENU screen displays.
1
Press c / d to select "OPTION".
2
Press a /b to select "OSD Time Out", and
3
then press OK.
Press a /b to select "Off", "10S", "20S",
4
"30S", "40S", "50S", "60S", "70S", "80S" or
"90S".
Blue Screen
Allows to set the screen display in blue when there is
no signal input.
Press MENU and the MENU screen displays.
1
Press c / d to select "OPTION".
2
Press a /b to select "Blue Screen", and then
3
press OK select "On" or "Off".
OSD Transparency
Allows to set the transparency of OSD menu.
Press MENU and the MENU screen displays.
1
Press c / d to select "OPTION".
2
Press a /b to select "OSD Transparency",
3
and then press OK.
Press a /b to select "Off", "10%", "20%",
4
"30%", "40%", "50%", "60%", "70%", "80%",
"90%" or "100%".
21
2016/1/27 22:58:50
Advertisement
Table of Contents
