Amana Side-by-Side Use And Care Manual page 7

™
Locate Touchmatic electronic control panel on
refrigerator between handles. Press * pad to activate
control panel. All other pads, except for Alarm Off pad,
remain inactive until * pad is pressed. Once activated,
pads remain programmable for at least 10 minutes.
®
Fresh Food and Deepfreeze controls are preset at 5.
Wait 24 hours for Fresh Food and Deepfreeze ® sections
to reach desired temperatures. After 24 hours, adjust
controls as desired. 1 is warmest setting and 9 is
®
coldest. Refer to instructions on page 6 to set
Deepfreeze Temp
temperatures precisely.
Fresh Food Temp
®
Adjust Fresh Food or Deepfreeze temperatures by
pressing * pad then Fresh Food Temp pad or
®
Deepfreeze Temp pad. Press Warmer pad or Colder
Warmer
pad to adjust temperature setting one level at a time.
Holding down Warmer pad or Colder pad adjusts
temperature more than one level at a time.
Colder
Vacation Mode
Vacation mode defrosts refrigerator less often during
extended non-use periods. Activate vacation mode by
pressing * pad then Vacation pad. Indicator light will
glow. Repeat above to deactivate vacation mode.
®
Opening Fresh Food or Deepfreeze door will also
deactivate vacation mode.
Max Cool Mode
Max cool mode adjusts Fresh Food temperature to
coldest setting. After 10 hours, Fresh Food temperature
automatically returns to previous setting. Activate max
cool mode by pressing * pad then Max Cool pad.
Indicator light will glow. Repeat above to deactivate max
cool mode before automatic reset.
Vacation
Fast Freeze Mode
Max Cool
®
Fast freeze mode adjusts Deepfreeze temperature to
®
coldest setting. After 24 hours, Deepfreeze
temperature automatically returns to previous setting.
Fast Freeze
Activate fast freeze mode by pressing * pad then Fast
Frz pad. Indicator light will glow. Repeat above to
Alarm Off
deactivate fast freeze mode before automatic reset.
Entry Tone
Display Off
Entry tone indicates a pad was pressed and command
was read and accepted. Deactivate entry tone by
pressing and holding * pad for three to five seconds.
Three short beeps indicate instructions were accepted.
Repeat above to activate entry tone.
7