Restoring Factory-Default Configuration Settings - D-Link DSR-500 User Manual

Unified Services Router



If yes, select
Settings
and enter that hostname as the ISP account name.

Many broadband ISPs restrict access by allowing traffic from the MA C address of
only your broadband modem; but some ISPs additionally restrict access to the MAC
address of just a single PC connected to that modem. If this is the case, configure
your firewall to clone or spoof the MAC address from the authorized PC.
11.4 Restoring factory-default configuration
settings
To restore factory-default configuration settings, do either of the following:
1.
Do you know the account password and IP address?


On the rear panel of the router, press and hold the Reset button about 10 seconds,
until the test LED lights and then blinks.
Release the button and wait for the router to reboot.
2.
If the router does not restart automatically; manually restart it to make the default settings
effective.
After a restore to factory defaults —whether initiated from the configuration interface or
3.
the Reset button — the following settings apply:





Verify that the network (subnet) address of your PC is different from the
network address of the remote device.
Verify that the cable or DSL modem is connected and functioning.
Ask your ISP if it assigned a hostname to your PC.
Network Configuration > WAN Settings > Ethernet ISP
Ask your ISP if it rejects the Ethernet MAC addresses of all but one of
your PCs.
Administration > Settings Backup & Upgrade
If yes, select
click default.
If no, do the following:
LAN IP address: 192.168.10.1
Username: admin
Password: password
DHCP server on LAN: enabled
WAN port configuration: Get configuration via DHCP
149
User Manual
and