Blucave Flashcell 4.6V Safety And Operating Manual page 9

Allow the Screwdriver to operate
without pressure. You will get better
results and you will be taking better
care of your tool.
Keep the area free of tripping hazards.
Do not let anyone under 18 years
operate this tool.
Only use accessory bits in good
condition.
Before screw driving, check that there
is sufficient clearance under the work
piece.
Do not touch the bit after operation. It
will be very hot.
Keep your hands away from under the
work piece.
Never use your hands to remove
sawdust, chips or waste close by the
bit.
Rags, cloths, cord, string and the like
should never be left around the work
area.
Support the work properly.
If you are interrupted when operating,
complete the process and switch off
before looking up.
Periodically check that all nuts,
bolts and other fixings are properly
tightened.
When using the Screwdriver, use
safety equipment including safety
glasses or shield, ear defenders, and
protective clothing including safety
gloves.
Do not charge the Screwdriver in
a place where static electricity is
generated nor let the battery touch
something that is statically charged.
Take care where the tool is stored. Do
not store in areas of corrosive fumes,
or salt air or similar conditions.
Do not dispose of the tool in a fire or
put the tool into a microwave oven,
conventional oven, dryer, or high-
pressure container.
conditions, the tool may explode.
Never attempt to open the tool,
puncture the casing of the tool, or
subject the tool to strong physical
shock. If the plastic housing of the tool
breaks open or cracks, immediately
discontinue its use and do not
recharge it.
Stop using the tool if it exhibits
abnormal heat, colour or deformation,
or if the tool is in an abnormal
condition.
After the tool has reached the end
of its useful life, we recommend
recycling the materials at your local
municipal council recycling centre. DO
NOT attempt to replace the Flashcell or
repair or modify any part of the tool.
When
conductive by applying insulating tape
to cover the terminals located on the
bottom of the Screwdriver's body.
The tool must be used only for its
prescribed purpose. Any use other
than those mentioned in this Manual
will be considered a case of misuse.
The user and not the manufacturer
shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must
observe
the assembly instructions and the
operating instructions to be found
in this Manual. All persons who use
and service the machine have to be
acquainted with this Manual and
must be informed about its potential
hazards.
Children and frail people must not
use this tool. Children should be
supervised at all times if they are in the
area in which the tool is being used. It
is also imperative that you observe
the accident prevention regulations in
force in your area. The same applies for
general rules of occupational health
and safety.
The manufacturer shall not be liable
for any changes made to the tool nor
Under these
9
recycling, make
the safety regulations,
BLUCAVE.COM
it non