Specifications; Operating Instructions; Charging Your Screwdriver; Operation Of The Screwdriver - Blucave Flashcell 4.6V Safety And Operating Manual

CAUTION: Carefully read this entire
instruction manual before using
this product take special care to
heed cautions and warnings.
When you open your case you will have
noticed some significant differences.
Please take some time to get to know
the features of your new product, as
they will make your work easier and
more efficient. The major advancement
in this product is the 60 second charge
time from empty. With Flashcell
Technology, your Screwdriver will
recharge in 60 seconds. It can be used
at any level of charge without damage
to the tool and has a recharge life of
over 100,000 cycles.

1. Charging your Screwdriver

Your cordless
Flashcells (Energy storage devices)
built into the product. You can start by
charging the Flashcells.
Remove your Charger (1) from the
packaging. Plug it into the mains
power and place it on a flat work
surface. When you turn on the mains
power the red LED on the charge level
indicator will illuminate. Take the
Screwdriver (5) and insert it into the
Charger vertically with the rear of the
Screwdriver being inserted into the
Charger. It will only fit in one way so do
not force it if it will not fit.
Once the Screwdriver is inserted the
charge level can be viewed on the
BLUCAVE.COM

SPECIFICATIONS

VOLTAGE:
CELL TYPE:
CHARGER:
CHARGING TIME:
NO LOAD SPEED:
MAX TORQUE:
BIT RETAINER SIZE
TOOL WEIGHT:

OPERATING INSTRUCTIONS

Screwdriver has
4.6V
Flashcell
110-120V ~60Hz
60 Seconds
200 RPM
3.32 ft-lb (4.5Nm)
1/4" (6.35mm)
0.81lb (366g)
Power Level Indicator (2).
charging is complete (approximately
60 seconds from empty) the Power
Level Indicator will be fully lit and
stop blinking. Note: You may remove
and use the Screwdriver at any time.
The charging process does not have
to be complete to use the tool and
short charges will not damage the
tool.

2. Operation of the Screwdriver

Once your Screwdriver is charged
remove it from the Charger. Select
the appropriate bit for the job and
insert into the Screwdriver Bit
Retainer (3). A magnet inside the
bit retainer will firmly hold the bit to
ensure it does not fall out.
To operate your Screwdriver select
the rotation direction with the
Forward/Reverse switch (6) then
squeeze the Trigger (7) to begin
operation.
Notes:
You must release the Trigger to
change direction of operation using
the Forward/Reverse switch.
DO NOT completely run down the
charge. DO NOT continue to use the
Screwdriver when the charge is
exhausted. The Screwdriver does
not have automatic spindle lock
and using the Screwdriver with no
charge may damage the tool.
4
Once