Download Print this page

Abtus A934-212C-044 Manual

In room control panel user programmable touch control panel
Hide thumbs Also See for A934-212C-044:

Advertisement

Quick Links

In Room

Control Panel

User Programmable
Touch Control Panel
Model: A934-212C-044
ABtUS SINGAPORE PTE LTD
ABtUS SINGAPORE PTE LTD
www.abtussingapore.com
www.abtussingapore.com

Advertisement

loading

Summary of Contents for Abtus A934-212C-044

  • Page 1: Control Panel

    In Room Control Panel User Programmable Touch Control Panel Model: A934-212C-044 ABtUS SINGAPORE PTE LTD ABtUS SINGAPORE PTE LTD www.abtussingapore.com www.abtussingapore.com...
  • Page 2: Table Of Contents

    CONTENT PAGE PRODUCT DESCRIPTION The ABtUS A934-212C-044 touch control panel uses a standard 4-wire resistive Overview : In Room Control Touch Panel A934-212C-044 touch panel, which allows up to a total of 32 command codes with complete user programmable software.
  • Page 3: Setting Up

    RS-232 for COM-1 Downloading of Software TYPICAL APPLICATIONS The programming software can be downloaded from “download center” in ABtUS Singapore’s website or at http://www.abtussingapore.com/download/E12C_V2.2E(100617).zip Any professional control system requiring multiple AV, lighting or environmental control. Schools (Media Classroom)
  • Page 4 User Operation Guide PROGRAMMING SOFTWARE E12C EDITOR V2.2E OVERVIEW ITEM DESCRIPTION Buttons : Physical “Button” location number and “Function” entry (Button number 1 to 12) Links : Virtual “Button” location number and “function” entry (Button number 13 to 32) Button Parameter *Each buttons are allow to have a independent parameter setting Setup : Baud Rate : 1200 to 38400...
  • Page 5: Button Layout

    Procedure of having the designed UI replaced : The UI layout on the touch panel can be configure into the following: To configure the UI layout, a separate firmware is required to be loaded. Firmware could be obtained from ABtUS Singapore on request. Latch...
  • Page 6: Uploading Of Program

    User Operation Guide UPLOAD OF PROGRAM UPLOAD OF PROGRAM Once the programming setup is done, program can be uploaded to the Touch Control panel accordingly : * Specifications are subject to changes without notice.
  • Page 7 User Operation Guide BUTTON FUNCTION NAME AND BAUD RATE SETTING EXAMPLE Once all button command code have been set, the “function name” and “Baud Rate setting” of each button can then be “Name” and “Set” accordingly. Once all of the above is completed, the “program” can then be uploaded to the Touch Control Panel accordingly. Please refer to the procedure in “Upload of Program”...
  • Page 8 User Operation Guide VIRTUAL LINK BUTTON MACRO SETTING BUTTON FUNCTION NAME Button 13 to 32 are virtual link buttons that are not to be confused with the 12 physical Once all button command codes have been set, the function name and Baud Rate setting for buttons.
  • Page 9: Rx/Up Settings

    User Operation Guide RX/UP SETTING EXAMPLE “UP” SETTING “RX” : The command transmitted can be set based on the RX return command whereas “UP” will acts as a “Push” and “Pop” action. Example : press and hold for dimming up of lights and release to stop dimming. EXAMPLE “RX”...