Advertisement
CABINET
CUTOUT
DFWD
MODELS
_L_
24"
1
9 s/8'q, /
[24.4 cm)'I-_I_
1
t
I
Cabinet
Model
DFWD171
DFWD101
25 1/4"
28 1/4"
A
(64.1 cm)
(71.8 cm)
Mounting Screws
(4) - #8 x 3/4"
Cavity Assy.
insulation
custom front
CUSTOM
FRONT
INSTALLATION
- DFWD
MODELS
• Open the drawer
and remove the pan.
• Center the custom front and insulation
around
the inside panel.
• NOTE:
Make sure the insulation
provided
is used between
the custom
panel and the inside door
panel.
• Attach
the custom
front with the (6) six #8 x 3/4" screws provided.
CABINET
INSTALLATION
*To remove drawer assembly, pull warming drawer pan out until fully extended.
Slide finger along the right and left
side until you reach the black hand latches (located at the front of the rails). Pull up on both the right and left latches
and pull drawer pan support completely out.
*For outdoor models ONLY - Apply silicon caulk that is provided all around the back of the warming drawer trim.
*Slide cavity assembly into cabinet opening.
*Drill (4) pilot holes in cabinet using 1/8" drill bit. Permanently secure the warming drawer using the (4) #8 mounting
screws provided.
*Replace drawer assembly.
Advertisement
