Advertisement
IMPORTANT
- PLEASE READ AND FOLLOW
• Before beginning, please read these instructions completely
and carefully.
• Do not remove permanently affixed labels, warnings, or
plates from the product. This may void the warranty.
• Please observe all local ordinances. If local codes are
applicable, wire in accordance with the National Electrical
Code, ANSI/NFPA 70 - latest edition.
•WARNING - To reduce the risk of electric shock and fire,
do not use a flexible power-supply cord with this
appliance.
•WARNING - FOR OUTDOOR INSTALLATION, INSTALLER
MUST INSTALL A GROUND FAULT INTERRUPT.
•The installer should leave these instructions with the
consumer who should retain for local inspector's use and
for future reference.
GENERAL INFORMATION
•THIS UNIT IS NOT TO BE INSTALLED BELOW
CABINETS OR WALL MOUNTED.
•When installing this unit directly below other units, only
install with Viking built-in products
• Remove warming drawer carefully from carLon. Remove all
loose packaging and accessories.
*it is the responsibility of the installer to comply with local
codes. If no local codes are applicable, wire in accordance
with the National Electrical Code, ANSI/NFPA 70 - latest
edition.
•This appliance is not fused. Protect with a proper sized fuse
or circuit breaker and a GFI for outdoor models.
• Line disconnect switch, circuit breaker, GFI (for outdoor
models) or plug/receptacle of power cord connection
should be readily accessible to the operator.
• Ground unit per applicable electrical codes.
*Any installation not matching the specifications discussed in
these instructions will void the manufacturer's warranty.
Make sure that incoming voltage is the same as
unit rating.
An electric rating plate specifying
voltage,
hertz, wattage,
amps, and phase is
attached to the product.
Wiring the warming
drawer with more voltage than it is rated for may
cause severe damage to the thermostat,
element, and other components.
Wiring the
warming
drawer with less voltage than it is rated
for may cause significant decrease in
performance.
To reduce the risk of fire, electric
shock, or injury to persons, installation
work and
electrical wiring must be clone by qualified
people in accordance
with all applicable
codes
and standards, including
fire-rated conditions.
ELECTRICAL
CONNECTION
- USE COPPER
CONDUCTORS
ONLY.
GROUNDING
INSTRUCTIONS
This appliance must be connected
to a grounded
metal,
permanent wiring system, or an equipment-grounding
conductor
must be run with the circuit conductors and
connected to the equipment-grounding
terminal or lead
on the appliance.
With the appliance positioned in front of the cabinet
opening,
connect wire leads extending from the power
supply to the terminal block of the unit. Make sure the
colored wires of the terminal block are connected to the
corresponding
colored wires extending from the power
supply.
BASIC
SPECIFICATIONS
MODEL
Interior width
Interior height
Interior depth
Electrical
Recluirements
Max. Amp Usage
Approx. shipping Wt.
VEWD173
VEWD173T
DEWD171
DFWD171
17 1/4 (43.8 cm)
6" (15.2 cm)
22 3/4" (27.8 cm)
VEWD103
VEWD103T
DEWD101
DFWD101
20 1/2" (52.1 cm)
6" (15.2 cm)
22 3/4" (27.8 cm)
VEWD163
VEWD163T
25" (63.5 cm)
6" (15.2 cm)
22 3/4" (27.8 cm)
Hard wire direct with separate 15 amp minimum 2-wire with
ground circuit; 120 VAC/50-60 Hz
425 watts
450 watts
550 watts
3.6 amps
3.8 amps
4.6 amps
80 lb. (36 kg)
90 lb. (40.5 kg)
110 lb. (49.5 kg)
Advertisement
