Page 1
ELECTRIC FLAT PANEL FIREPLACE HEATER Model Number: EFW-XB34B OWNER’S MANUAL Wall Hanging Mode Pedestal Mode Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Failure to do so could WARNING result in fire, electric shock, or serious personal injury.
Page 2
WARNING Read all instructions before using this heater! This heater is hot when in use. To avoid burns, DO NOT let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the heater, and keep them away from the sides and rear.
Page 3
For residential use only! NOT for commercial use! Any commercial or public use of this heater voids all warranties, and could cause injury. This product is not intended to be a primary heat source. It is for supplemental heat only. INDOOR use only! NEVER use this heater outdoors! Doing so may result in electric shock! Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside! NEVER modify this heater.
This product includes a GLASS! Always use extreme caution when handling glass. Failure to do so could result in personal injury or property damage. Remove all contents from the carton and place them on a clean, soft, dry surface. Check to make sure nothing is missing.
Page 5
The wall mount fasteners included with this fireplace are for use ONLY with a NOTICE wood-framed wall covered in drywall (sheet rock). For concrete walls, cinder blocks, or other wall types, consult a professional for the best attachment methods. ALWAYS unplug this fireplace heater before assembly or cleaning, or before relocating.
Page 6
STEP 4. Align the holes in the wall bracket (E) with the pilot holes and drywall anchors. Thread three wood screws (B) through the holes in the wall bracket and directly into the wall studs and drywall anchor(s). Make sure the bracket is level. Tighten all screws securely with a screwdriver. ALWAYS unplug this fireplace heater before assembly or cleaning, or before relocating.
Page 7
Foot Pedestal Assembly STEP 6. Secure pedestal foot (G) to the bottom of the fireplace (A) with two M6x14 bolts (E). Tighten each screw securely with a Phillips screwdriver. STEP 7. Repeat Step 6 Using remaining pedestal foot (G) Decorative Fuel Bed Installation This next step involves GLASS! ALWAYS use extreme caution when handling glass.
Operation Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Failure to do so could result in electric shock, fire, serious injury, or death. Power Make sure the ON/OFF switch, located on the left side panel, is in the OFF position. Plug the power cord into a 110~120 Volt 15 Amp grounded outlet (see IMPORTANT SAFETY INFORMATION on Pages 2 and 3).
Control Panel Operation BUTTON ACTION and INDICATION CONTROL PANEL 1. Press ON (l). Power turns on. All functions are enabled. 2. Press OFF (O). Power, flame effect, and all functions turn off. 1. Press once. Flame effect and indicator turn on. 2.
Page 10
When the heater is first turned on, a slight odor may be present. This is normal and NOTICE should not occur again unless the heater is not used for a long period of time. To improve operation, aim the remote control at the front of the fireplace. DO NOT NOTICE press the buttons too quickly.
Temperature Limiting Control This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature (212°F / 100°C), the heater will automatically turn OFF. To reset: a. Unplug the power cord from the outlet. b. Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes. c.
ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury. Electrical and Moving Parts: The fan motors are lubricated at the factory and will not require lubrication. Electrical components are integrated in the fireplace and are not serviceable by the consumer.
Need help?
Do you have a question about the EFW-XB34B and is the answer not in the manual?
Questions and answers