Razor FLASHRIDER 360 Owner's Manual page 5

ASSEMBLY AND SET -UP
q Attaching the Front Fork
Required Tools: 13 mm wrench and 5 mm Allen wrench
1 Remove the steering bolt and
locknut from the frame assembly
with a 13 mm wrench and a 5 mm
Allen wrench.
4 Reinsert the steering bolt and
secure with locknut using a 13 mm
wrench and a 5 mm Allen wrench.
q Attaching the Front Wheel
Required Tools: 5 mm Allen wrench and 10 mm wrench
1 Remove the four (4) coupling
bolts from the front fork using a
5 mm Allen wrench and a 10 mm
wrench.
2 Insert the front fork into the
frame assembly.
2 Insert the wheel assembly into
the front fork and align holes.
When installing the wheel, make
sure the letter "F" and arrow
(located on the side of the wheel)
are facing the direction as shown
above.
3 Be sure to properly align the
slot on the headtube with the pin
on the front fork as shown.
3 Reinsert the coupling bolts
through the front fork and tighten
securely.
4
WARNING: Failing
to properly tighten the steering
bolt that attaches the front fork
assembly to the frame assembly can
cause you to lose control and fall.