Assembly And Set-Up - Razor FLASHRIDER 360 Owner's Manual

ASSEMBLY AND SET -UP
q Attaching the Frame
Required Tools: Two (2) 5 mm Allen wrenches
1 Using two (2) 5 mm Allen
wrenches, remove the coupling
bolt on the end of the frame and
discard the plastic insert. Remove
the coupling bolt in the middle of
the frame.
Note: This coupling bolt is shorter.
q Attaching the Spark Bar
Required Tools: 10 mm wrench and 5 mm Allen wrench
1 Using a 10 mm wrench and a
5 mm Allen wrench, remove the
coupling bolts from the Spark
Handle.
Need Help? Visit our website for replacement parts and product support at www.razor.com or call toll-free at
866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time. Please have the product I.D. code (located on the
bottom of the frame) available for better assistance.
2 Insert the rear frame into the
frame assembly. Securely tighten
the coupling bolt on the rear
frame using two (2) 5 mm Allen
wrenches.
2 Insert the Spark Handle (right
side) and the Spark Bar (left side)
into the spring mechanism. Align
the holes on the Spark Bar with
the hole on the spring mechanism
and tighten the coupling bolt with
a 10 mm wrench and a 5 mm Allen
wrench.
3 Securely tighten the coupling
bolt in the middle of the frame
using two (2) 5 mm Allen
wrenches.
3 Align the holes on the Spark
Handle with the holes on the
Spark Bar and tighten the coupling
bolts with a 10 mm wrench and a
5 mm Allen wrench.
3