Before Operation; Safety Precautions - Ega Master 79904 Operating Instructions Manual

ENGLISH
The performance / output power of this machine is designed for drilling of different workpieces and materials. The
machine must be held tight against rotation. Make use of the second handle during hammer drilling.
• Check the oil level. If necessary add oil to fill up the oiler. (Line oiler or Service Unit).
• Clamp the drill into three-jaw chuck.
• Connect air hose. (In order to remove contaminants, blow out the air hose before connecting).
Actuate valve and begin the drilling operation. (Speed can be regulated by opening the valve
more or less).
• Shut the valve.
• Turn off compressed air and disconnect the air hose.
• Unclamp the drill if necessary.
• Check the oiler.
Any power tool can be dangerous. Please follow these simple safety procedures - they are for your protection.
• Do not use this machine in any other way than as directed by these operating instructions.
• Hold the machine tight during operation. When operating with the hammer drill also use the second handle.
• Regular maintenance is essential - check all screws, fittings etc. for tightness.
• Check air hose for damage.
• Make sure the unit is lubricated.
• Never use dull tools or drills.
• Avoid sparks in hazardous environment - created by the drill. Always flush material and drill for cooling with
sufficient water.
• Wear protective clothing.
• Wear safety glasses, non-slip gloves and ear protectors.
• Ensure that you maintain a safe working position.
• Never work under the influence of alcohol, drugs or stronger medication.
• Always disconnect machine from the air line for changing drills or working on the machine.
GENERAL

BEFORE OPERATION

AFTER FINISHING THE OPERATION

SAFETY PRECAUTIONS

9