Advertisement
Quick Links
Advertisement
Related Manuals for Elite Robo-Pad
Summary of Contents for Elite Robo-Pad
- Page 1 FULL BODY SHIATSU...
- Page 2 Assembly Instructions...
- Page 5 To Begin: External Electric Plug On/off Fuse Power cord The auto program buttons will begin to flash after the body scanning has completed. you can now select a manual or auto program. Instruction manual...
- Page 6 On Display: Description Buttons On Display: Instruction manual...
- Page 8 Assembly Instructions Assembly Instructions Elite Robo-Pad Assembly Instructions. For questions, clarifications or Locate the two wire plugs and air pipe on the right side of the chair. These plugs should protrude from the square opening shown in the below picture. The wires may...
- Page 9 Assembly Instructions Assembly Instructions Step 2: Install left arm. Repeat the procedure for step one. Note that there are two additional plugs for the Screw hole location left arm, three total, as shown below. Connect the plugs and air pipe accordingly. Arm screw locations, The remainder of the procedure is the same as the right arm remove screws...
- Page 10 Assembly Instructions Assembly Instructions Locate the mounting location for the speaker / air bag assembly on the chair, remove Remove the plastic covering panel from the rear of the speaker assembly. Remove the one screw from the edge of the panel. You may have to gently pry the screws from this location the panel off of the assembly using a small flat head screwdriver.
- Page 11 Assembly Instructions Assembly Instructions Connect the air pipe and wire. Insert screws previously removed from side of chair Install the controller stand onto the controller stand mount on the right arm, making through holes shown below. sure to line up the indent on the bottom of each piece. Insert screws into each side of the controller stand Insert Side view of chair with...
Need help?
Do you have a question about the Robo-Pad and is the answer not in the manual?
Questions and answers
How do I activate the audio can I Bluetooth my phone to it
To activate the audio on the Elite Robo-Pad and connect your phone via Bluetooth:
1. On your Apple mobile device, go to Settings > Bluetooth and turn Bluetooth on.
2. On the massage chair, go to the lower right-hand corner and turn off the main power.
3. Wait five seconds, then turn the chair back on.
4. You should hear a series of tones from the chair’s speakers—this means it’s now in Bluetooth discovery mode.
5. On your mobile device, wait for it to discover the chair. It may appear as a series of numbers, letters, or "PHI HONEST".
6. Tap on the device name to connect.
7. If prompted for a PIN, enter 0000.
8. Once paired, you can now play music from your mobile device through the chair’s speakers.
This answer is automatically generated
It just stopped working, my mom went to use it and it just wouldn't come on?
The Elite Robo-Pad may not be turning on due to several possible reasons:
1. External Electric Plug – Ensure the power cord is properly connected to an external power source.
2. On/Off Switch – Verify that the chair's power switch is turned on.
3. Fuse Issue – Check if the fuse is intact; a blown fuse may prevent the chair from powering on.
4. Loose Connections – Confirm that all wire plugs and air pipes are properly connected, as improper assembly may cause power issues.
If the issue persists, further troubleshooting or contacting support may be necessary.
This answer is automatically generated