Symcod LS6300 Quick Start Manual

LS6300 laser
WWW.SYMCOD.COM
USB
Guide de démarrage rapide
1. Utiliser le câble requis selon l'interface choisie.
2. Brancher le câble sur le périphérique.
3. Lire le code « Default » code pour remettre la
configuration d'origine.
4. Aller à la section « OUTPUT MODE »
5. Configuration USB, scanner le code sous :
"OUTPUT MODE – KEYBOARD / USB"
6. Configuration RS-232, scanner le code sous :
"OUTPUT MODE – SERIAL RS232"
Quick Start Guide
1. Use the cable required for the selected interface
2. Connect the cable to the device
3. Scan the « Default » code to reset the scanner to the
factory configuration.
4. Go to « OUTPUT MODE » section
5. USB configuration, scan code under :
"OUTPUT MODE – KEYBOARD / USB"
6. RS-232 configuration, scan code under :
"OUTPUT MODE – SERIAL RS232"
Default
OUTPUT MODE –
RS-232
KEYBOARD / USB
OUTPUT MODE – WAND
SINGLE SCAN
LASER TIMEOUT
–5 SECONDS
CODE 11 DOUBLE
CHECK - ENABLE
CODE 39 DOUBLE
CHECK ENABLE
CODE 93 DOUBLE
CHECK - ENABLE
OUTPUT
OUTPUT MODE –
MODE
SERIAL RS232
READING
SINGLE SCAN NO
MODE TRIGGER
LASER TIMEOUT
–2 SECONDS
DOUBLE CODE 11 DOUBLE
CHECK CHECK - DISABLE
CODE 39 DOUBLE
CHECK DISABLE
CODE 93 DOUBLE
CHECK - DISABLE
CODE 128 DOUBLE
CHECK – ENABLE DOUBLE CHECK -
I2OF5 DOUBLE I2OF5 DOUBLE
DOUBLE
CHECK - ENABLE
CHECK - DISABLE
CHECK
ID2OF5 DOUBLE ID2OF5 DOUBLE
CHECK - ENABLE CHECK - DISABLE
MSI DOUBLE MSI DOUBLE
CHECK - ENABLE CHECK - DISABLE
UPC/EAN DOUBLE
CHECK ENABLE DOUBLE CHECK
REVERSE IMAGE REVERSE IMAGE
IMAGE
– ENABLE
SEND BAR CODE ID SEND BAR CODE
CODE ID
- DISABLE ID – AS A PREFIX
SEND BAR CODE
SEND BAR CODE ID
ID – AS A SUFFIX
- RESET
CODE 128
UPC/EAN
- DISABLE