Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Factor Electronics PA-1000
Summary of Contents for Factor Electronics PA-1000
- Page 1 PA-1000/PA-2000 Professional Stereo Power Amplifiers User and Installation Manual...
-
Page 2: Important Safety Instructions
SAFETY INSTRUCTIONS CAUTION! TO REDUCE THE RISK OF WARNING! TO REDUCE THE RISK OF SHOCK, DO NOT REMOVE THE COVER, FIRE OR ELECTRIC SHOCK, DO NOT NO USER SERVICABLE PARTS INSIDE. EXPOSE THIS APPLIANCE TO RAIN RISK OF ELECTRIC SHOCK OR MOISTURE. -
Page 3: Product Overview
SMPS which reduce the amplifier weight, heat, distortion, noise and power consumption while increasing amplifier power output and overall performance. The PA-1000/2000 provide state of the art protection circuitry like thermal, short circuit, output DC offset and power ON/OFF muting to eliminate pops and thumps when powering your audio system. A switchable limiter is also provided which protects the amplifier and connected speakers from input overload conditions. - Page 4 PA-1000/2000 AMPLIFIER REAR PANEL BREAKER operates like a fuse protecting the amplifier from damage. Press the breaker switch to re-set after an AC overload condition Balanced XLR female line level audio Twist lock speaker connectors input connectors channels A/B Channel A/B Pin 1 –...
-
Page 5: Installation
PA-1000/2000 INSTALLATION INSTRUCTIONS IMPORTANT: The PA-1000/2000 should be situated in a well ventilated location or position. Do not block the vents on the front/back of the chassis. Proper ventilation is required for normal operation. Do not expose the unit to excessive dust and do not allow dust to build up on the unit and block the vent holes in the chassis. - Page 6 PA-1000/2000 INSTALLATION INSTRUCTIONS BRIDGE MONO operation. Set the MODE switch to BRI – BRIDGE. Dual Amplifier BRIDGE MONO operation. Set the MODE switch to The two independent internal amplifiers will be combined to create a BRI – BRIDGE. The two independent internal amplifiers will be combined single high power amplifier.
- Page 7 IMPORTANT: The PA-1000/2000 amplifiers are capable of driving constant voltage high impedance speaker systems in BRIDGE MONO Mode (PA-1000) or in STEREO MODE using the PA-2000 where each channel is capable of 1000 watts output per channel. Constant voltage systems are more commonly referred to as 25 volt or 70 volt systems or commercial sound systems. With this type of system all speakers must be connected to a 25 volt or 70 volt transformer which reflects a higher impedance back to the amplifier.
-
Page 8: Input Impedance
/distributor and transportation to the dealer/ distributor the unit was purchased from or S/N RATIO >100dB >100dB Factor Electronics. This warranty does not apply to units that have been subject to CROSSTALK >70dB >70dB misuse, abuse, neglect or improper installation, DAMPING FACTOR >500...