Advertisement
11.NOTE: If the camera is to be side mounted on the helmet, be certain that
the red dot is always pointed to the 12 O'clock position. Failure to do this
will result in a rotated alignment image.
12.Once the proper location has been found, remove the adhesive protection
and press the camera tube onto the helmet. NOTE: The adhesive used for
the Velcro is very strong. During the first 5 minutes of application, gently
pealing it back and re-locating the position can remove it. However, it
does cure after about an hour and then it becomes very difficult to remove
the Velcro.
13.Dress the video and power cables down the back of the helmet and con-
nect your recording device.
GENERAL NOTES:
1. Do not use any other battery charger than the unit provided with LAIRD-
CAM. The use of any other charging device may result in damage to the
camera and voids all warrantees.
2. Never immerse the camera in water. The ruggedized camera tube is weath-
erproof against rain, water splashes and environmental moisture, but it
should not be immersed in water or any liquid for any length of time.
3. The VECRO provided is very strong and care should be exercised when sep-
arating the two strips.
4. Do not use the battery provided to run any device except the camera.
Separate power must be provided for any other device.
5. The Battery is a 12Volt, 800maH lead acid battery and is matched to the
charger provided. Do not plug the battery into any charger than the one
provided.
LTM-LCAM
LAIRDCAM
Helmet Camera System
- Page 5 -
Advertisement
