Advertisement
2. The camera has two mount systems. The Helmet CAM and the base
mount. To use the Helmet system it is necessary to first mount the camera in
the provided camera tube. Locate the camera tube.
3. Insert the camera all the way until it stops (do not force).
4. Locate the 2 set screws
provided in the plastic bag.
6. Align the camera red dot to the 12 O'clock position of the tube: do this
on a flat surface.
7. Tighten (do not over tighten) the setscrews to hold the camera in place.
LTM-LCAM
LAIRDCAM
Helmet Camera System
Locate the assembly pack (small plastic bag) located
a)
front left of the carry pack.
Notice the camera has a red dot locate on the rear of the
b)
camera. This dot indicates the Top Dead Center of the
camera. Insert the camera into the tube with the lens of
the camera facing the protective Plexiglas on the tube.
Red Locating Dot
5. Insert set screws into the two
holes on the camera tube.
- Page 3 -
Advertisement
