Drainage System Troubleshooting; Reduction In Water Flow From Bilge Pump; Bilge Pump Continues To Run Even Though Bilge Is Dry; Bilge Is Full Of Water And Pump Is Not Running - KeyWest Technology 152CC/1520 Sportsman Quick Manual

Drainage System Troubleshooting

Blue Intake screen on bottom of pump is clogged with debris. Clean Intake Screen

Reduction in water flow from bilge pump

Voltage to the pump is low. Check for corrosion and loose connections. Check battery Voltage
• Discharge hose is blocked or kink. Check discharge hose and clean/repair
• Pump is defective. Replace Pump
•
• Float switch on pump is stuck due to debris or build up on switch. Ensure float switch is clean and free of

Bilge Pump continues to run even though bilge is dry

debris
•
The Inline Fuse for the automatic bilge pump is blown. Replace the Fuse

Bilge is full of water and pump is not running

The battery is dead. Check voltage and charge if necessary
• The pumps impeller is clogged by debris. Clean pump impeller
• The connections/wires to the pump are corroded. Check and replace connections/wires
• The Built-In float switch is defective. Replace Pump
• The Pump is defective. Replace Pump
•
• ATC Fuse on fuse block is blown. Replace Fuse. (1520)
Bilge pump will not run when the manual switch on the helm is engaged
Circuit Breaker on dash panel has tripped. Reset Circuit Breaker (152)
• The battery switch is off or the battery is disconnected. Turn on battery switch/reconnect battery
• The pumps impeller is clogged by debris. Clean pump impeller
• Switch is defective. Replace the switch
• The connections/wires to the pump are corroded. Check and replace connections/wires
• Pump is defective. Replace Pump
•
•