Turbo Air TAR-4 Owner & Operator Instruction Manual page 4

INSTALLATION & OPERATION INSTRUCTION
CLEARANCE
The appliance area must be kept free and clear of all combustible. This unit is design-certified for
the following installation only:
The clearances from combustible and non-combustible construction for ranges and range mounted
salamander broiler or cheesemelter are as follows:
Combustible Construction
BACK
SIDES
FLOOR
If legs or casters are not used, the unit must extend 2" beyond the front edge of a noncombustible
curb or platform.
CAUTION
DO NOT PUSH against the end of the valve cover/landing ledge in an attempt to adjust the ranges
position. Although this part is deburred during manufacturing,an accident could occur if the range
should move suddenly while being pushed unto position by hand.
HIGH SHELF ASSEMBLY
(1) Mount the high shelf riser to the range with #10 sheet metal screws(pointed tips) in the back.
(2) Mount the high shelf to the riser with #10 sheet metal screws provided (See attachment at the
end of this manual for a diagram that describes the installation of the backguard/flue riser).
NOTE: If a Salamander broiler / Cheesemelter is to be mounted on range, read installation instruc-
tions for Salamander broiler / Cheesemelter before installing high shelf. Special care must be taken
to ensure that the gas supply piping and/or gas pressure regulator is not exposed to exhaust gases
or elevated temperatures.
8"
12"
Non-Combustible
4
Non-Combustible Construction
0
0
6"