Dismantling Instructions; Dismantling Of The Front Panel Assembly; Dismantling Of The Dvd Module And/Or Digital Board - Philips MX1060D Service Manual

DISMANTLING INSTRUCTIONS

Dismantling of the Front Panel Assembly

1) Open the DVD Tray by using the Open/Close Button while
the Set is ON and disconnect the mains supply after
removing the Tray Cover.
Note: If this is not possible, the DVD Tray has to be open
manually.
To manually open the DVD Tray, place the set on its right
side. Insert a mini flat screw driver into the slot and slide
it upwards as shown in figure 2 until the Tray moves out of
the Front Panel.
Figure 1
3-1
2) Return the set to its upright position and remove the Tray
Cover as shown in Figure 1 and close the tray manually by
pushing it back in.
3) Loosen 9 screws and remove the Top Cover by lifting the
rear portion upwards before sliding it out towards the rear.
- 5 screws on the rear
- 2 screws each on the left & right side
4) Loosen 5 screws & lift up the top edge of Front Panel
assembly to free some catches (see figure 3) before
sliding it out towards the front.
- 3 screws on the bottom
- 1 screw each on the left & right side
Figure 2

Dismantling of the DVD Module and/or Digital Board

1) Loosen 10 screws A to remove the DVD Digital Board
cover as shown in figure 2.
Note: Use step 3 to remove the Digital Board without
dismantling the complete DVD Module.
2) Loosen 6 screws B (including 2 metal mounting brackets)
and 2 catches C1 as shown in figure 4 and 5. Disconnect
4 cables (see figure 6) and remove the DVD Module by
lifting its rear end upward and sliding it out of the Front
Metal plate.
Figure 4
Figure 5
3-1
Note: - Care should be taken not to entangle / damage
the grounding springs along the DVD enclosure
wall.
- Do not loose the 2 metal mounting brackets.
3) Loosen 4 screws D (see figure 6) and all connectors to
remove the Digital Board.
Figure 3
Figure 6