Axis M3006-V User Manual page 47

AXIS M3006–V Network Camera
Troubleshooting
Lower frame rate than
expected
Video and image problems, general
Image unsatisfactory
Disturbed focus
Motion Detection triggers unexpectedly
Changes in luminance
Storage and disk management problems
Video cannot be recorded
SD card cannot be mounted
See Performance Considerations, on page 50.
Reduce the number of applications running on the client computer.
Limit the number of simultaneous viewers.
Check with the network administrator that there is enough bandwidth available.
Check in the AMC Control Panel (H.264 tag) that video processing is NOT set to Decode only
key frames.
Lower the image resolution.
Set a Capture Mode that prioritizes frame rate. Changing the capture mode to prioritize frame rate
will lower the maximum resolution. SeeCapture Mode, on page 17.
The maximum frames per second is dependent on the utility frequency (60/50 Hz) of the Axis
product. See Technical Specifications, on page 48.
Check the video stream and camera settings under Setup > Video > Video Stream and Setup >
Video > Camera Settings.
Set the focus manually by turning the focus ring. See Hardware Overview, on page 4
Motion detection is based on changes in luminance in the image. This means that if there are
sudden changes in the lighting, motion detection may trigger mistakenly. Lower the sensitivity
setting to avoid problems with luminance.
Check that the SD card is not write protected (that is, read only).
Reformat the SD card and then click Mount.
47