Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ProAudio MT12
Summary of Contents for ProAudio MT12
- Page 1 Manual MT12 Multi-purpose Speaker...
-
Page 2: Table Of Contents
• Operating Modes [1] MT12 Fullrange ......[2] MT12 with Subwoofer ...... -
Page 3: General Safety And Care Instructions
flying rails and the tripod flange. Replace them if necessary. Make sure that during operation on spacer tubes, no persons will stand close to the loudspeakers. Use only accessory parts specified by ProAudio Technology or original accessory parts from ProAudio Technology. Loudspeakers always produce a magnetic field. Make sure... -
Page 4: Description And Use
SW18 / SW28 subwoofers. pins have been reversed. Pin pair 2 is connected to the speaker. Only one 4-pole cable is required Combinations of MT12 and subwoofers, which are fed via a 4- to connect two e.g. monitor paths elegantly without additional... -
Page 5: Operating Modes
Operation modes [1] MT12: DELTA 8.4-DSP The four loudspeakers are wired using 4-pole speaker cables. Each amplifier channel will drive one speaker. Four amplifier channels will be assigned. DELTA 8.4-DSP The eight loudspeakers are wired using 4-pole speaker cables. Each amplifier channel will drive two speakers. -
Page 6: Mt12 With Subwoofer
Two amplifier channels will be assigned. Channels three and four may be used to set up an identical configuration. [2] MT12 with Subwoofer: DELTA 8.4-DSP The subwoofer is wired together with one top using 4-pole speaker cables. - Page 7 DELTA 8.4-DSP One subwoofer and two tops on either side are wired using 4-pole speaker cables. Each amplifier channel will drive one subwoofer and two tops in stereo mode. Four amplifier channels will be assigned. DELTA 8.4-DSP Two subwoofers and one top on either side are wired using 4-pole speaker cables.
- Page 8 DELTA 8.4-DSP The subwoofer is wired together with one top using 4-pole speaker cables. Likewise, the second top and the fullrange speaker are wired using 4-pole speaker cables. Each amplifier channel will drive one speaker. Three amplifier channels will be assigned for the PA. The two tops are run in stereo, the subwoofer in mono mode.
-
Page 9: Mt12 As Nearfield Speaker
[3] MT12 as Nearfield Speaker Rear Rear Rear Rear DELTA 14.4-DSP DELTA 14.4-DSP DELTA 14.4-DSP The six subwoofers per side are wired using 4-pole speaker cables. The nearfield speakers are connected to the amplifier with 4-pole speaker cables. The two tops are each connected to the pin-reversed socket of the nearfield speaker using... -
Page 10: Drawings / Dimensions
Drawings / Dimensions:... -
Page 11: Technical Specifications
The relevant regulations must be observed and adhered to. EU Conformity Declaration: This declaration is valid for the MT12 loudspeaker of the manufacturing company ProAudio Technology GmbH. Included herein are all production items of the same type, as long as they have not been modified subsequently in structural or... - Page 12 Manual MT12 Multi-purpose speaker – 2012-11 ENG ProAudio Technology GmbH Hermann-Schwer-Strasse 3 78048 Villingen-Schwenningen Germany Phone: +49 (0) 77 21 / 99 81 96 - 0 Fax: +49 (0) 77 21 / 99 81 96 - 9 info@proaudio-technology.de www.proaudio-technology.de...