Setting Up; D800 Setup - Aviom A 360 Display User Manual

Setting Up

Each A360 Personal Mixer in a personal mixing system communicates with one of the eight A-Net ports on
a D800 or D800-Dante A-Net Distributor to provide its mix information over Wi-Fi to an iOS device.
It's important to set up each component—your iOS device, the Wi-Fi router, the D800, and the A360—
properly in order to use A360 Display successfully with your monitor mixing system.
Your A360 Personal Mixers and D800 A-Net Distributors will also need to be running the latest firmware
to take advantage of the features offered by A360 Display. Firmware updates are available on the Aviom
website and require a USB memory stick to install.

D800 Setup

Connect the Ethernet port on the rear of the D800 (or D800-Dante) to the Wi-Fi router with a Cat-5 cable.
(Each D800 should be connected to its own Wi-Fi router.)
No internet connection is required to use A360 Display.
The Wi-Fi router is connected to the Ethernet port on the D800 rear-panel.
On the D800 front panel, connect the A360 Personal Mixers to the A-Net ports. For each A360 that
will be using A360 Display, move the D800's front panel switch to the "II" position to enable two-way
communication.
A360 D U G 3
isplAy ser UiDe