Replacement Of Memory Ic; Service Adjustment; Focus Adjustment - Haier NS-F27C Service Manual

Table of Contents

7.REPLACEMENT OF MEMORY IC

1. MEMORY IC.

This TV uses memory IC. In the memory IC are memorized data for correctly operating the

video and deflection circuits.

When replacing memory IC, be sure to use IC written with the initial value of data.

2. PROCEDURE FOR REPLACING MEMORY IC

(1) Power off

Switch the power off and unplug the power cord from AC outlet.

(2) Replace IC

Be sure to use memory IC written with the initial data values.

(3) Power On

Plug the power cord into the AC outlet and switch the power On.

(4) Check and set SYSTEM default value:

1) Press "QV" key holding about 4 second and then press "MENU1" key on the Remote

control unit. Or Press "TEST" key on the Remote control unit for factory used.

2) The "TEST" will be displayed on the screen.

3) Press digital key, (Mkey) and corresponding on-screen display will be appeared.

Some time "PASSWORD" on-screen display will be appeared, you need to input 828.

4) Check the setting value of the SYSTEM default value of Table below. If the value is

different, select items by [CH+]/[CH-] keys and set value by [VOL+]/[VOL-] keys.

5) Press "STANDBY" key again and return to the normal screen.

B1 POWER SUPPLY

1. Receive normal colour bar signal.

2. Connect DC voltmeter to VD541- and isolated ground.

3. Adjust potentiometer in power unit to get the voltage as 130V ±1.0V for 29 inch hereinafter,

130 ±1.0V for 25 inch upwards.

1. Receive a crosshatch signal.

2. While watching the screen, adjust the FOCUS VR to make the vertical and horizontal lines as

fine and sharp as possible.

Replacement of memory IC

Table of Contents